384
DWS-1008 User’s Manual
D-Link Systems, Inc.
Appendix A - Troubleshooting
To filter the event log by MSS area, use the
facility
facility-name
keyword. For a list of
facilities for which you can view event messages, type the following command:
DWS-1008#
show log buffer facility ?
<facility name> Select one of: KERNEL, AAA, SYSLOGD, ACL, APM, ARP,ASO,
BOOT, CLI, CLUSTER, COPP, CRYPTO, DOT1X, ENCAP, ETHERNET, GATEWAY, HTTPD,
IGMP, IP, MISC, NOSE, NP, RAND, RESOLV, RIB, ROAM, ROGUE, SM, SNMPD, SPAN,
STORE, SYS, TAGMGR, TBRIDGE, TCPSSL, TELNET, TFTP, TLS, TUNNEL, VLAN, X509,
XML, AP, RAPDA, WEBVIEW, EAP, PORTCONFIG, FP.
To clear the buffer, type the following command:
DWS-1008#
clear log buffer
To disable logging to the system buffer, type the following command:
DWS-1008#
set log buffer disable
Logging to the Console
By default, console logging is enabled and messages at the error level and higher are sent
to the console.
To modify console logging, use the following command:
set log console severity
severity-level
For example, to set logging to the console for events at the critical severity level and higher,
type the following command:
DWS-1008#
set log console severity critical
success: command accepted.
To disable console logging, type the following command:
DWS-1008#
set log console disable
success: change accepted.
The console is always available, but it has the following limitations:
• Console logging is slow.
• Messages logged to the console are dropped if the console output buffer overflows.
MSS displays a message indicating the number of messages dropped.
• If you type anything to the console, the typing disables log output to the console until
you press the Enter key.
Summary of Contents for DWS-1008
Page 1: ......
