36
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuration (continued)
Configuration
Configure the same Distributed AP on each of the switches you want to use to manage the AP
access point associated with the Distributed AP. Make sure to use the same Distributed AP
number and serial ID on each switch. To display configuration information for all Distributed
APs configured in the MobileLAN, use the following command:
show dap global [dap-num | serial-id serial-ID]
The following command lists configuration information for the Distributed APs below:
DWS-1008#
show dap global
Total number of entries: 12
DAP Serial Id
Switch IP Address
Bias
------ -----------------
-------------------------
------
1
0322199999
10.10.10.4
HIGH
-
0322199999
10.10.40.4
HIGH
-
0322199999
10.10.50.4
HIGH
2
0322199998
10.10.10.4
HIGH
-
0322199998
10.10.40.4
HIGH
-
0322199998
10.10.50.4
HIGH
-
0322199997
10.10.40.4
HIGH
-
0322199997
10.10.50.4
HIGH
-
0322199996
10.10.40.4
HIGH
-
0322199996
10.10.50.4
HIGH
-
0322199995
10.10.40.4
HIGH
-
0322199995
10.10.50.4
HIGH
This example assumes that each switch is configured with a Distributed AP connection
(DAP) for each AP that is not directly connected to the switch. The APs that are directly
connected to 10.10.10.4 (switch1) are not configured as Distributed APs on switch1, but they
are configured as Distributed APs on the other switches. On Switch1, the directly connected
APs are configured using AP access ports, with the
set port type ap
command.
A DAP number is listed only for Distributed APs that are configured on the switch on which
you type the command. For Distributed APs configured on other switches, a hyphen ( - )
is displayed in the DAP field. The bias determines the switch a Distributed AP prefers for
booting, configuration, and data transfer.
Summary of Contents for DWS-1008
Page 1: ......
