72
DWS-1008 User’s Manual
D-Link Systems, Inc.
Configuring and Managing Ports and VLANs
After you configure a port group, you can use the port group name with commands that
change Layer 2 configuration parameters to apply configuration changes to all ports in the
port group. For example, Spanning Tree Protocol (STP) and VLAN membership changes
affect the entire port group instead of individual ports. When you make Layer 2 configuration
changes, you can use a port group name in place of the port list. Ethernet port statistics
continue to apply to individual ports, not to port groups.
To configure a port group named
server2
containing ports 3 and 5 and add the ports to the
default
VLAN, type the following commands:
DWS-1008#
set port-group name server2 3,5 mode on
success: change accepted.
DWS-1008#
set vlan default port server2
success: change accepted.
To verify the configuration change, type the following command:
DWS-1008#
show vlan config
Admin
VLAN
Tunl
Port
VLAN Name
Status
State
Affin Port
Tag State
-----------------------------------------------------------------------------------------------------------
1
default
Up
Up
5
server2
none Up
To indicate that the ports are configured as a port group, the
show vlan config
output lists
the port group name instead of the individual port numbers.
Removing a Port Group
To remove a port group, use the following command:
clear port-group name
name
Displaying Port Group Information
To display port group information, use the following command:
show port-group
[
all
|
name
group-name
]
To display the configuration and status of port group
server2
, type the following command:
DWS-1008#
show port-group name server2
Port group: server2 is up
Ports: 3, 5
Interoperating with Cisco Systems EtherChannel
Summary of Contents for DWS-1008
Page 1: ......
