D-Link DWS-1008 User Manual
10
Configuring Uplink Fast Convergence
To enable or disable uplink fast convergence, use the following command:
set spantree uplinkfast {enable | disable}
Displaying Uplink Fast Convergence Information
To display uplink fast convergence information, use the following command:
show spantree uplinkfast [vlan
vlan-id
]
The following command displays uplink fast convergence information for all VLANs:
DWS-1008#
show spantree uplinkfast
VLAN
port list
-----------------------------------
1
1(fwd),2,3
In this example, ports 1, 2, and 3 provide redundant links to the network core. Port 1 is forwarding traffic.
The remaining ports block traffic to prevent a loop.
Displaying Spanning Tree Information
You can use CLI commands to display the following STP information:
• Bridge STP settings and individual port information
• Blocked ports
• Statistics
• Port fast, backbone fast, and uplink fast convergence information
Note: For information about the show commands for the fast convergence features, see “Configuring
and Managing STP Fast Convergence Features”.
Summary of Contents for DWS-1008
Page 1: ......
