92 © 2001- 2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access System User Manual
If you access the Access Point Profile Radio configuration through the Advanced
Configuration > AP Profile > Radio tab, some additional fields are available for
configuration.
The following table describes the fields for the AP radio that are only available from the
Advanced Configuration menu.
Configuring SSID Settings
The SSID tab displays the virtual access point (V1AP) settings associated with the default AP
profile. Each VAP has an associated network, which is identified by its network number and
Initial Power
The automatic power algorithm will not reduce the power below the number
you set in the initial power field. By default, the power level is 100%.
Therefore, even if you enable the automatic power, the power of the RF
signal will not decrease.
The power level is a percentage of the maximum transmission power for the
RF signal.
Antenna Diversity
Select the antenna use to receive and transmit wireless traffic:
•
Auto: Automatically select the best antenna to send and receive traffic.
•
Primary: Use the primary antenna to send and receive traffic.
•
Secondary: Use the secondary antenna to send and receive traffic.
Table 10.
Advanced Radio Configuration
Field
Description
RF Scan Duration
This field controls the amount of time the radio spends scanning the other
channel (in milliseconds) during an RF scan.
Transmit Lifetime
Shows the number of milliseconds to wait before terminating attempts to
transmit the MSDU after the initial transmission.
Receive Lifetime
Shows the number of milliseconds to wait before terminating attempts to
reassemble the MMPDU or MSDU after the initial reception of a fragmented
MMPDU or MSDU.
Frag Threshold
The fragmentation threshold limits the size of packets transmitted over the
network. Acceptable values are even numbers from 256-2345. Packets that
are under the configured size are not fragmented. A value of 2346 means that
packets are not fragmented.
Short Retries
The value in this field indicates the maximum number of transmission
attempts on frame sizes less than or equal to the RTS Threshold. The range is
1-255.
Long Retries
The value in this field indicates the maximum number of transmission
attempts on frame sizes greater than the RTS Threshold. The range is 1-255.
Table 9.
Radio Settings
Field
Description
Summary of Contents for DWS-3024L
