DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
390
38-2
delete link_aggregation group_id
Description
This command is used to delete a configured link aggregation group.
Format
delete link_aggregation group_id <value 1-32>
Parameters
group_id
- Specifies the group id. The group number identifies each of the groups.
<value 1-32>
- Enter the group ID value here. This value must be between 1 and 32.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To delete link aggregation group:
DWS-3160-24PC:admin# delete link_aggregation group_id 3
Command: delete link_aggregation group_id 3
Success.
DWS-3160-24PC:admin#
38-3
config link_aggregation
Description
This command is used to configure a link aggregation group.
Format
config link_aggregation group_id <value 1-32> {master_port <port> | ports <portlist> | state
[enabled | disabled]}
Parameters
group_id
- Specifies the group id. The group number identifies each of the groups.
<value 1-32>
- Enter the group ID value here. This value must be between 1 and 32.
master_port
- (Optional) Master port ID. Specifies which port (by port number) of the link
aggregation group will be the master port. All of the ports in a link aggregation group will share
the port configuration with the master port.
<port>
- Enter the master port number here.
ports
- (Optional) Specifies a range of ports that will belong to the link aggregation group. The
port list is specified by listing the lowest Switch number and the beginning port number on that
Switch, separated by a colon. Then highest Switch number, and the highest port number of
the range (also separated by a colon) are specified. The beginning and end of the port list
range are separated by a dash.
