DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
466
Chapter 46
MLD Snooping Multicast
(MSM) VLAN Command List
create mld_snooping multicast_vlan
<vlan_name 32> <vlanid 2-4094> {remap_priority [<value
0-7> | none] {replace_priority}}
config mld_snooping multicast_vlan
<vlan_name 32> {[add | delete] [member_port <portlist> |
[source_port <portlist> | untag_source_port <portlist>] | tag_member_port <portlist>] | state
[enable | disable] | replace_source_ip <ipv6addr> | remap_priority [<value 0-7> | none]
{replace_priority}}(1)
create mld_snooping multicast_vlan_group_profile
<profile_name 1-32>
config mld_snooping multicast_vlan_group_profile
<profile_name 1-32> [add | delete]
<mcast_v6address_list>
delete mld_snooping multicast_vlan_group_profile
[profile_name <profile_name 1-32> | all]
show mld_snooping multicast_vlan_group_profile
{<profile_name 1-32>}
config mld_snooping multicast_vlan_group
<vlan_name 32> [add | delete] profile_name
<profile_name 1-32>
show mld_snooping multicast_vlan_group
{<vlan_name 32>}
delete mld_snooping multicast_vlan
<vlan_name 32>
enable mld_snooping multicast_vlan
disable mld_snooping multicast_vlan
config mld_snooping multicast_vlan forward_unmatched
[disable | enable]
show mld_snooping multicast_vlan
{<vlan_name 32>}
46-1
create mld_snooping multicast_vlan
Description
This command is used to create an MLD snooping multicast VLAN. More than one multicast
VLANs can be created. Newly created MLD snooping multicast VLANs must use a unique VLAN
ID and name. They cannot use the VLAN ID or name of any existing 802.1Q VLAN.
Also keep in mind the following conditions:
•
Multicast VLANs cannot be configured or displayed using 802.1Q VLAN commands.
•
An IP interface cannot be bound to a multicast VLAN.
•
The multicast VLAN snooping function co-exists with the 802.1Q VLAN snooping function.
Format
create mld_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {remap_priority
[<value 0-7> | none] {replace_priority}}
Parameters
<vlan_name 32>
- Enter the multicast VLAN name here. This name can be up to 32 characters
long.
<vlanid 2-4094>
- Enter the multicast VLAN ID here. This value must be between 2 and 4094.
remap_priority
- (Optional) Specifies the remap priority value, to be associated with the data
traffic forwarded on the multicast VLAN.
<value 0-7>
- Enter the remap priority value here. This value must be between 0 and 7.
none
- Specifies that the remap priority value will be set to none. The packet’s original priority
