DWS-3160 Series Gigabit Ethernet Unified Switch CLI Reference Guide
718
default
- Specifies that the default option will be used.
rts_threshold
- Specifies the RTS threshold for the radio. This indicates the number of octets
in an MPDU, below which an RTS/CTS handshake shall not be performed.
<int 0-2347>
- Enter the RTS threshold value used here. This value must be between 0
and 2347. The default value is 2347.
default
- Specifies that the default value will be used.
station_isolation
- Specifies whether to enable or disable the Station Isolation mode on the
radio. When Station Isolation is enabled, the access point blocks communication between
wireless clients. The access point still allows data traffic between its wireless clients and
wired devices on the network, but not among wireless clients.
enable
- Specifies that the Station Isolation mode, on the radio, will be enabled.
disable
- Specifies that the Station Isolation mode, on the radio, will be disabled. This is
the default option.
vap
- Specifies the Virtual Access Point (VAP) configuration, per radio interface, within an
access point profile.
<int 0-15>
- Enter the VAP value used here. This value must be between 0 and 15.
state
- Specifies whether to enable or disable the configured VAP on the radio. VAP0
cannot be disabled. If you want to disable VAP0, you must turn off the radio option.
enable
- Specifies that the configured VAP, on the radio, will be enabled.
disable
- Specifies that the configured VAP, on the radio, will be disabled. This is the
default option.
network
- Specifies the network to apply to the VAP. A VAP must be configured with a
network.
<int 1-64>
- Enter the network ID used here. This value must be between 1 and 64.
wmm
- Specifies whether to enable or disable the WMM mode for the radio. WMM mode is
known as Wi-Fi Multimedia mode. When enabled the QoS settings it'll affect both the
downstream traffic to the station (AP EDCA parameters) and the upstream traffic to the AP
(station EDCA parameters). When disabled, the QoS will only be applied to the
downstream traffic.
enable
- Specifies that the WWM mode, for the radio, will be enabled. This is the default
option.
disable
- Specifies that the WWM mode, for the radio, will be disabled.
Restrictions
Only Administrators can issue this command.
Example
To apply an AP Profile to a WS Managed APs associated with the AP Profile:
DWS-3160-24PC:admin#config wireless ap_profile 1 apply
Command: config wireless ap_profile 1 apply
Do you want to apply the configuration to all managed APs associated with this
profile? (y/n) y
AP Profile apply is in progress.
Success.
DWS-3160-24PC:admin#
To restore AP Profile 1’s configuration to the default values:
