DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
188
Figure 10-59 Add Egress ACL Profile window (IPv6 ACL)
The fields that can be configured are described below:
Parameter
Description
Profile ID (1-4)
Enter a unique identifier number for this profile set. This value can be set from
1
to
4.
Profile Name
Enter a profile name for the profile created.
Select ACL Type
Select profile based on Ethernet (MAC Address), IPv4 address, or IPv6 address.
This will change the window according to the requirements for the type of profile.
Select Ethernet ACL to instruct the Switch to examine the layer 2 part of each
packet header.
Select IPv4 ACL to instruct the Switch to examine the IPv4 address in each
frame's header.
Select IPv6 ACL
to instruct the Switch to examine the IPv6 address in each
frame's header.
IPv6 Class
Ticking this check box will instruct the Switch to examine the
class
field of the IPv6
header. This class field is a part of the packet header that is similar to the Type of
Service (ToS) or Precedence bits field in IPv4.
IPv6 TCP
Source Port Mask
– Specify that the rule applies to the range of TCP source ports.
Destination Port Mask
– Specify the range of the TCP destination port range.
IPv6 UDP
Source Port Mask
– Specify the range of the UDP source port range.
Destination Port Mask
– Specify the range of the UDP destination port mask.
ICMP
Select
ICMP
to instruct the Switch to examine the Internet Control Message
Protocol (ICMP) field in each frame's header.
IPv6 Source Mask
The user may specify an IP address mask for the source IPv6 address by ticking
the corresponding check box and entering the IP address mask, e.g.
