DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
278
Auto
- MIPs can always be created on any ports in this MA, if that port is not configured
with a MEP of that MA.
Explicit
- MIP can be created on any ports in this MA, only if the next existent lower
level has a MEP configured on that port, and that port is not configured with a MEP of
this MA.
Defer
- Inherit the setting configured for the maintenance domain that this MA is
associated with. This is the default value.
SenderID
This is the control transmission of the sender ID TLV.
None
- Don’t transmit sender ID TLV. This is the default value.
Chassis
- Transmit sender ID TLV with chassis ID information.
Manage
- Transmit sender ID TLV with manage address information.
Chassis Manage
- Transmit sender ID TLV with chassis ID information and manage
address information.
Defer
- Inherit the setting configured for the maintenance domain that this MA is
associated with. This is the default value.
CCM
This is the CCM interval.
10ms
- 10 milliseconds. Not recommended. For test purpose.
100ms
- 100 milliseconds. Not recommended. For test purpose.
1sec
- One second.
10sec
- Ten seconds. This is the default value.
1min
- One minute.
10min
- Ten minutes.
MEP ID(s)
This is to specify the MEP IDs contained in the maintenance association. The range of
the MEP ID is 1-8191.
Add
- Add MEP ID(s).
Delete
- Delete MEP ID(s).
By default, there is no MEP ID in a newly created maintenance association.
Click the
Apply
button to accept the changes made.
After clicking the
MIP Port Table
button, the following page will appear:
Figure 13-4 CFM MIP Port Table Window
Click the
<<Back
button to return to the previous window.
After clicking the
Add MEP
button, the following page will appear:
Figure 13-5 CFM MEP Settings (Add) Window
