DWS-3160 Series Gigabit Ethernet Unified Switch Web UI Reference Guide
411
Address
provisioned.
New Backup IP
Address
Tick the check box and enter IP address of the backup switch that the AP to be
provisioned.
Profile ID
Use the drop-down menu to select the profile ID to be used when provisioning.
Click the
Apply
button to accept the changes made.
Click the
Delete
button to remove the entry.
Click the
Provision the AP
button to perform provisioning.
Advanced Configuration
Global
This window is used to configure wireless advanced settings.
To view this window, click
Administration > Advanced Configuration > Global
as shown below:
Figure 3-22 Global General window
The fields that can be configured are described below:
Parameter
Description
Peer Group ID
Enter a peer group ID to configure wireless switches as peers. Peer switches share
some information about APs and allow L3 roaming among them.
Client Roam Timeout
(secs)
Enter a time in second to determine how long to keep an entry in the Associated
Client Status list after a client has disassociated.
Ad Hoc Client Status
Timeout (hours)
Enter a time in hour to determine how long to keep an entry in the Ad Hoc Client
Status list.
AP Failure Status
Timeout (hours)
Enter a time in hour to determine how long to keep an entry in the AP
Authentication Failure Status list.
MAC Authentication
Mode
Select the global action to take on wireless clients in the
white-list
or
black-list
.
white-list
– Specify that any wireless clients with MAC addresses, specified in the
Known Client database and not explicitly denied access, are granted access. If the
MAC address is not in the database then the access to the client is denied.
black-list
- Select this option to specify that any wireless clients with MAC
