DXS-3326GSR Stackable Gigabit Layer 3 Switch
show multicast_fdb
Purpose
Used to display the contents of the Switch’s multicast forwarding
database.
Syntax
show mulitcast_fdb [vlan <vlan_name 32> | mac_address
<macaddr>]
Description
This command is used to display the current contents of the
Switch’s multicast MAC address forwarding database.
Parameters
<vlan_name 32>
−
The name of the VLAN on which the MAC
address resides.
<macaddr>
−
The MAC address that is present in the forwarding
database table.
Restrictions None.
Example usage:
To display multicast MAC address table:
DXS-3326GSR:4#show multicast_fdb
Command: show multicast_fdb
VLAN Name : default
MAC Address : 01-00-5E-00-00-00
Egress Ports : 1:1-1:5,1:26,2:26
Mode : Static
Total Entries : 1
DXS-3326GSR:4#
show fdb
Purpose
Used to display the current unicast MAC address forwarding
database.
Syntax
show fdb {port <port> | vlan <vlan_name 32> | mac_address
<macaddr> | static | aging_time}
Description
This command will display the current contents of the Switch’s
forwarding database.
Parameters
port <port>
−
The port number corresponding to the MAC
destination address. The Switch will always forward traffic to the
specified device through this port. The port list is specified by
listing the lowest switch number and the beginning port number
on that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
97
