DXS-3326GSR Stackable Gigabit Layer 3 Switch
Example usage:
To configure LACP port mode settings:
DXS-3326GSR:4#config lacp_port 1
:
1-1
:
12 mode active
Command: config lacp_port 1
:
1-1
:
12 mode active
Success.
DXS-3326GSR:4#
show lacp_port
Purpose
Used to display current LACP port mode settings.
Syntax
show lacp_port {<portlist>}
Description
This command will display the LACP mode settings as they are
currently configured.
Parameters
<portlist>
- Specifies a range of ports that will be viewed. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4
−
in numerical order.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To display LACP port mode settings:
DXS-3326GSR:4#show lacp_port 1:1-1:8
Command: show lacp_port 1:1-1:8
Port Activity
------ --------
1:1 Active
1:2 Active
1:3 Active
1:4 Active
1:5 Active
1:6 Active
1:7 Active
1:8 Active
DXS-3326GSR:4#
137
