DXS-3326GSR Stackable Gigabit Layer 3 Switch
config 802.1x auth_parameter
tx_period <sec 1-65535>
- Configures the time to wait for a
response from a supplicant (user) to send EAP Request/Identity
packets.
supp_timeout <sec 1-65535>
- Configures the time to wait for a
response from a supplicant (user) for all EAP packets, except for
the Request/Identity packets.
server_timeout <sec 1-65535>
- Configure the length of time to
wait for a response from a RADIUS server.
max_req <value 1-10>
−
Configures the number of times to retry
sending packets to a supplicant (user).
reauth_period <sec 1-65535>
−
Configures the time interval
between successive re-authentications.
enable_reauth [enable | disable]
−
Determines whether or not the
Switch will re-authenticate. Enabled causes re-authentication of
users at the time interval specified in the Re-authentication Period
field, above.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication parameters for ports 1 – 20 of switch 1:
DXS-3326GSR:4#config 802.1x auth_parameter ports 1:1 – 1:20 direction both
Command: config 802.1x auth_parameter ports 1:1-1:20 direction both
Success.
DXS-3326GSR:4#
config 802.1x auth_protocol
Purpose
Used to configure the 802.1x authentication protocol on the
Switch.
Syntax
config 802.1x auth_protocol [local | radius_eap]
Description
The
config 802.1x auth_protocol
command enables you to
configure the authentication protocol.
Parameters
[local | radius_eap]
– Specify the type of authentication protocol
desired.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure the authentication protocol on the Switch:
214
