DXS-3326GSR Stackable Gigabit Layer 3 Switch
create access_profile
profile on the Switch and to define which parts of each incoming
frame’s header the Switch will examine. Masks can be entered
that will be combined with the values the Switch finds in the
specified frame header fields. Specific values for the rules are
entered using the
config access_profile
command, below.
Parameters
ethernet
−
Specifies that the Switch will examine the layer 2 part
of each packet header.
ip
−
Specifies that the Switch will examine the IP address in each
frame’s header.
•
vlan
−
Specifies that the Switch will examine the VLAN part
of each packet header.
•
source_mac <macmask>
−
Specifies a MAC address mask
for the source MAC address. This mask is entered in the
following hexadecimal format:
000000000000-FFFFFFFFFFFF
•
destination_mac <macmask>
−
Specifies a MAC address
mask for the destination MAC address. This mask is entered
in the following hexadecimal format:
000000000000-FFFFFFFFFFFF
•
802.1p
−
Specifies that the Switch will examine the 802.1p
priority value in the frame’s header.
•
ethernet_type
−
Specifies that the Switch will examine the
Ethernet type value in each frame’s header.
•
vlan
−
Specifies a VLAN mask.
•
source_ip_mask <netmask>
−
Specifies an IP address mask
for the source IP address.
•
destination_ip_mask <netmask>
−
Specifies an IP address
mask for the destination IP address.
•
dscp
−
Specifies that the Switch will examine the DiffServ
Code Point (DSCP) field in each frame’s header.
•
icmp
−
Specifies that the Switch will examine the
Internet Control Message Protocol (ICMP) field in each
frame’s header.
•
type
−
Specifies that the Switch will examine each
frame’s ICMP Type field.
•
code
−
Specifies that the Switch will examine each
frame’s ICMP Code field.
•
igmp
−
Specifies that the Switch will examine each frame’s
Internet Group Management Protocol (IGMP) field.
•
type
−
Specifies that the Switch will examine each
frame’s IGMP Type field.
228
