DXS-3326GSR Stackable Gigabit Layer 3 Switch
27
S
TACKING
C
OMMANDS
The stacking configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command Parameters
config box_priority
current_box_id <value 1-12> priority <value 1-16>
config box_id
current_box_id <value 1-12> new_box_id [AUTO | 1 | 2 | 3 | 4 | 5
| 6 | 7 | 8 | 9 | 10 | 11 | 12]
current_box_id <value 1-12> type [DGS-3324SR | DXS-3350SR |
DXS-3326GSR | BOX_NOTEXIST]
[static_mode | auto_mode]
config box_type
config all_boxes_id
show stack_information
Each command is listed, in detail, in the following sections.
config box_priority
Purpose
Used to configure box priority, which determines which box
becomes master. Lower numbers have higher priority.
Syntax
config box_priority {current_box_id <value 1-12> priority
<value 1-16>}
Description
This command configures box (switch) priority.
Parameters
current_box_id <value 1-12>
– Identifies the Switch being
configured. Range is 1-12.
priority <value 1-16>
– Assigns a priority value to the box, with
lower numbers having higher priority. Range is 1-16.
Only
administrator-level users can issue this command.
Restrictions
Usage Example:
To configure box priority:
DXS-3326GSR:4#config box_priority current_box_id 1 priority 1
Command: config box_priority current_box_id 1 priority 1
Success.
DXS-3326GSR:4#
239
