DXS-3326GSR Stackable Gigabit Layer 3 Switch
config ospf ipif
Designated Router (DR). A number between 0 and 255.
hello_interval <sec 1-65535>
−
Allows the specification of the
interval between the transmission of OSPF Hello packets, in
seconds. Between 1 and 65535 seconds can be specified. The
Hello Interval, Dead Interval, Authorization Type, and Authorization
Key should be the same for all routers on the same network.
dead_interval <sec 1-65535>
−
Allows the specification of the
length of time between the receipt of Hello packets from a neighbor
router before the selected area declares that router down. An
interval between 1 and 65535 seconds can be specified. The Dead
Interval must be evenly divisible by the Hello Interval.
metric <value 1-65535 >
−
The interface metric (1 to 65535).
Entering a 0 will allow automatic calculation of the metric.
authentication
– Enter the type of authentication preferred. The
user may choose between:
metric <value 1-65535>
−
This field allows the entry of a number
between 1 and 65,535 that is representative of the OSPF cost of
reaching the selected OSPF interface. The default metric is 1.
state [enable | disable]
– Used to enable or disable this function.
Restrictions Only
administrator-level users can issue this command.
none
– Choosing this parameter will require no
authentication.
simple <password 8>
−
Choosing this parameter will set a
simple authentication which includes a case-sensitive
password of no more than 8 characters.
md5 <key_id 1-255>
−
Choosing this parameter will set
authentication based on md5 encryption. A previously
configured MD5 key ID (1 to 255) is required.
Usage Example
To configure OSPF interface settings:
DXS-3326GSR:4#config ospf ipif System priority 2 hello_interval 15
metric 2 state enable
Command: config ospf ipif System priority 2 hello_interval 15
metric 2 state enable
Success.
DXS-3326GSR:4#
328
