DXS-3326GSR Stackable Gigabit Layer 3 Switch
7
N
ETWORK
M
ANAGEMENT
(SNMP) C
OMMANDS
The network management commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
The DXS-3326GSR supports the Simple Network Management Protocol (SNMP) versions 1, 2c, and 3. You can specify which
version of the SNMP you want to use to monitor and control the Switch. The three versions of SNMP vary in the level of
security provided between the management station and the network device. The following table lists the security features of the
three SNMP versions:
SNMP Version
Authentication Method
Description
v1 Community
String
Community String is used for authentication
−
NoAuthNoPriv
v2c Community
String
Community String is used for authentication
−
NoAuthNoPriv
v3 Username
Username is used for authentication
−
NoAuthNoPriv
v3
MD5 or SHA
Authentication is based on the HMAC-MD5 or HMAC-SHA
algorithms
−
AuthNoPriv
v3
MD5 DES or SHA DES
Authentication is based on the HMAC-MD5 or HMAC-SHA
algorithms
−
AuthPriv.
DES 56-bit encryption is added based on the CBC-DES
(DES-56) standard
Each command is listed, in detail, in the following sections.
Command Parameters
create snmp user
create snmp user <SNMP_name 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha
<auth_password 8-20>] priv [none | des <priv_password 8-16>] |
by_key auth [md5 <auth_key 32-32> | sha <auth_key 40-40>] priv
[none | des <priv_key 32-32>]]}
delete snmp user
<SNMP_name 32>
show snmp user
create snmp view
<view_name 32> <oid> view_type [included | excluded]
delete snmp view
<view_name 32> [all | oid]
show snmp view
<view_name 32>
create snmp
community
<community_string 32> view <view_name 32> [read_only |
read_write]
delete snmp
community
<community_string 32>
show snmp
community
<community_string 32>
config snmp engineID
<snmp_engineID>
33
