DXS-3326GSR Stackable Gigabit Layer 3 Switch
9
N
ETWORK
M
ONITORING
C
OMMANDS
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
show packet ports
<portlist>
show error ports
<portlist>
show utilization
[ports | cpu]
clear counters
ports <portlist>
clear log
show log
index <value_list>
enable syslog
disable syslog
show syslog
create syslog host
[<index 1-4 | all > ] {severity [informational | warning | all] | facility
[local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] |
udp_port <udp_port_number> | ipaddress <ipaddr> | state [enable
| disable]}
config syslog host
<index 1-4> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | ipaddress <ipaddr> | state [enable |
disable]}
config syslog host all
{severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | state [enable | disable]}
delete syslog host
[<index 1-4 | all>]
show syslog host
[<index 1-4>]
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Used to display statistics about the packets sent and received by
the Switch.
Syntax
show packet ports <portlist>
Description
This command is used to display statistics about packets sent and
received by ports specified in the port list.
Parameters
<portlist>
−
Specifies a range of ports to be displayed. The port list
is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end
62
