DXS-3326GSR Stackable Gigabit Layer 3 Switch
DXS-3326GSR:4#show utilization ports
Port TX/sec RX/sec Util Port TX/sec RX/sec Util
---- ---------- ---------- ---- ---- ---------- ---------- ----
1:1 0 0 0 1:22 0 0 0
1:2 0 0 0 1:23 0 0 0
1:3 0 0 0 1:24 0 0 0
1:4 0 0 0 1:25 0 0 0
1:5 0 0 0 1:26 19 49 1
1:6 0 0 0 2:1 0 0 0
1:7 0 0 0 2:2 0 0 0
1:8 0 0 0 2:3 0 0 0
1:9 0 0 0 2:4 0 0 0
1:10 0 0 0 2:5 0 0 0
1:11 0 0 0 2:6 0 0 0
1:12 0 0 0 2:7 0 30 1
1:13 0 0 0 2:8 0 0 0
1:14 0 0 0 2:9 30 0 1
1:15 0 0 0 2:10 0 0 0
1:16 0 0 0 2:11 0 0 0
1:17 0 0 0 2:12 0 0 0
1:18 0 0 0 2:13 0 0 0
1:19 0 0 0 2:14 0 0 0
1:20 0 0 0 2:15 0 0 0
1:21 0 0 0 2:16 0 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
To display the current cpu utilization:
DXS-3326GSR:4#show utilization cpu
Command: show utilization cpu
CPU utilization :
-------------------------------------------------------------------------------
Five seconds - 15% One minute - 25% Five minutes - 14%
DXS-3326GSR:4#
clear counters
Purpose
Used to clear the Switch’s statistics counters.
Syntax
clear counters {ports <portlist>}
Description
This command will clear the counters used by the Switch to compile
statistics.
Parameters
<portlist>
−
Specifies a range of ports to be configured. The port list
is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
65
