DXS-3410 Series
Layer 3 Stackable Managed Switch
Hardware Installation Guide
7
3.
Installation
Installation Guidelines
This section will cover the hardware installation guidelines that the user needs to adhere to for the correct and safe
installation of this Switch in the suitable environment.
Visually inspect the power cord to ensure it is securely connected to both the power connector on the Switch
and the electrical outlet providing power.
Position the Switch in a cool and dry location within the specified operating temperature and humidity ranges.
Place the Switch in a location that is devoid of powerful electromagnetic field generators, such as motors,
vibrations, dust, and direct sunlight exposure.
Installing the Switch without a Rack
This section provides guidance for users installing the Switch in a location outside of a Switch rack. Affix the provided
rubber feet to the underside of the Switch. Please be aware that there are designated areas marked on the bottom of
the Switch indicating where the rubber feet should be attached. These markings are typically located in each corner
on the underside of the device. The rubber feet serve as cushions for the Switch, safeguarding the casing against
scratches and preventing it from causing scratches on other surfaces.
Figure 3-1 Attaching rubber feet to the Switch
Place the Switch on a stable, even surface capable of bearing its weight. Avoid putting heavy objects on the Switch.
The power outlet should be located within 1.82 meters (6 feet) of the Switch. Ensure sufficient heat dissipation and
proper ventilation around the Switch. Allow a minimum of 10 cm (4 inches) of clearance at the front, sides, and rear of
the Switch for ventilation.
Summary of Contents for DXS-3410 Series
Page 1: ...Version 1 00 2023 12 18...
Page 54: ......