D-Link EasySmart Switch User Manual
26
Figure 46– L2 Features > Loopback Detection
Loopback Detection State:
Use the drop-down menu to enable or disable loopback detection. The default
is
Disabled.
Interval (1-32767):
Set a Loop detection Interval between
1
and
32767
seconds. The default is
1
seconds.
Recover Time (0 or 60-1000000):
Time allowed (in seconds) for recovery when a Loopback is detected.
The Loop Detection Recover Time can be set at
0
seconds, or
60
to
1000000
seconds. Entering
0
will
disable the Loop Detection Recover Time. The default is
60
seconds.
From Port:
The beginning of a consecutive group of ports may be configured starting with the selected port.
To Port:
The ending of a consecutive group of ports may be configured starting with the selected port.
State:
Use the drop-down menu to toggle between
Enabled
and
Disabled.
Default is
Disabled
.
Click
Apply
to implement changes made.
L2 Features > Statistics
The Statistics screen displays the status of each port packet count.
Figure 47– L2 Features > Statistics menu
Refresh All:
Renews the details collected and displayed.
Clear All Counters:
To reset the details displayed.
TxOK:
Number of packets transmitted successfully.
