79
D-Link DIR-X4860 User Manual
Section 3 - Configuration
Static Route - IPv4
In the Features menu on the bar at the top of the page, click
Static Route
to define custom routes, controlling how data
traffic is moved around your network.
To configure the Static Route IPv6 settings, click the
IPv6
link. Refer to
Click
Save
at any time to save the changes you have made on this page.
If you wish to remove a route, click on the trash can icon in the Delete column. If you wish
to edit a route, click on the pencil icon in the Edit column. If you wish to create a new route,
click the
Add Route
button.
If you clicked on
Edit
or
Add Rule
, the following options will appear:
Name
Enter a name for the rule.
Destination Network
Enter the IP address of packets that will take this route.
Mask
Enter the subnet mask of the route.
Gateway
Enter your next hop gateway to be taken when this route is
used.
Metric
Enter a route metric value ranging from
0
to
15
. This value
indicates the cost of using this route.
Interface
Select the interface that the IP packet must use to transit out
of the router when this route is used.
