8
This is the default page when the utility starts up.
Status:
Shows the BSSID associated, which can be used to identify the wireless network.
SSID:
Shows current SSID, which must be the same for the wireless client and AP in order for communication to be established.
TxRate:
Shows the current data rate used for transmitting.
Channel:
Shows the current channel for communication.
Radio Off
button: When clicked, you disable the radio signal, and cut-off the wireless connection.
Link Quality
: Shows the link quality of the 22Mbps wireless Network PCI Adapter with the Access Point when operating under
Infrastructure mode.
Signal Strength
: Shows the wireless signal strength of the connection between the 22mpbs wireless Network PCI Adapter with the
Access Point.
Data Rate: Shows the statistics of data transfer, and the calculation is based on the number of packets transmitted and received.
Configuration Page
This is the page where you can change the basic settings of the Access Point with the minimum amount of effort to adjust a secure
wireless network.
SSID:
Service Set Identifier, which is a unique name shared among all clients and nodes in a wireless network. The SSID must be
identical for each clients and nodes in the wireless network.
BSS Type:
There are two types available for selection
z
Infrastructure – to establish wireless communication with LAN and other wireless clients through the use the Access
Points.
z
Ad-Hoc – to establish point-to-point wireless communication directly with other wireless client devices such as
