D-Link KVM-440, User Manual

3

7

Disclaimer 

Information in this document is subject to change without notice. The manufacturer does not make any representations or 
warranties (implied or otherwise) regarding the accuracy and completeness of this document and shall in no event be liable for 
any loss of profit or any other commercial damage, including but not limited to special, incidental, consequential, or other 
damages. 
     
No part of this document may be reproduced or transmitted in any form by any means, electronic or mechanical, including 
photocopying, recording or information recording and retrieval systems without the express written permission of the 
manufacturer.   
 
All brand names and product names used in this document are trademarks, or registered trademarks of their respective 
holders.  
 

Federal Communication Commission Interference Statement 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC 
Rules.    These limits are designed to provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications.    However, there is no guarantee that interference will 
not occur in a particular installation.    If this equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the 
following measures: 
 

•

Reorient or relocate the receiving antenna. 

•

Increase the separation between the equipment and receiver. 

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

•

Consult the dealer or an experienced radio/TV technician for help. 

FCC Caution:

 Any changes or modifications not expressly approved by the party responsible for compliance could void the 

user's authority to operate this equipment. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may 
not cause harmful interference, and (2) this device must accept any interference received, including interference that may 
cause undesired operation. 
 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC 
Rules.  
 
These limits are designed to provide reasonable protection against harmful interference in a residential installation. 
 

Industry Canada Statement 

This Class B digital apparatus complies with Canadian ICES-003. Operation is subject to the following two conditions: (1) this 
device may not cause interference, and (2) this device must accept any interference, including interference that may cause 
undesired operation of the device. 
 
Cet appareil numérique de la classe B conforme á la norme NMB-003 du Canada.