2.1.278. base64_decode_failed (ID: 00200658)
Default Severity
Log Message
IMAPALG: Base 64 decode failed. Attachment blocked
Explanation
The data sent to Base64 decoding failed. This can occur if the email
sender sends incorrectly formatted data. The attachment has been
blocked.
Gateway Action
block_data
Recommended Action
Research how the sender is encoding the data.
Revision
1
Parameters
filename
filetype
sender_email_address
Context Parameters
2.1.279. command_blocked (ID: 00200659)
Default Severity
Log Message
IMAPALG: Command <command> blocked.
Explanation
The client is sending command that are not allowed. The command
will be blocked.
Gateway Action
block
Recommended Action
If
the
command
are
to
be
allowed
change
the
Alg
configuration.Note: The STLS command is allways blocked!.
Revision
1
Parameters
command
Context Parameters
2.1.280. unknown_command_blocked (ID: 00200660)
Default Severity
Log Message
IMAPALG: Unknown command blocked.
Explanation
The client is sending unknown command. The command will be
blocked.
Gateway Action
block
Chapter 2: Log Message Reference
156
Summary of Contents for NetDefend DFL-260E
