Default Severity
Log Message
The file <filename> has too many archive levels. Maximum allowed
is <max_depth>.
Explanation
The file archive exceeds the maximum allowed depth. Since Fail
Mode is set to Deny the data transfer will be aborted in order to
protect the receiver.
Gateway Action
block_data
Recommended Action
Change Fail Mode parameter to Allow if files that fail decompression
should be allowed without scanning. Increase the Max. Archive
Depth parameter to allow deeper files to be scanned.
Revision
1
Parameters
filename
max_depth
[layer7_srcinfo]
[layer7_dstinfo]
Context Parameters
ALG Module Name
ALG Session ID
Connection
2.3.23. max_archive_depth_exceeded (ID: 05800029)
Default Severity
Log Message
The file <filename> has too many archive levels. Maximum allowed
is <max_depth>.
Explanation
The file archive exceeds the maximum allowed depth. Since Fail
Mode is set to Allow the data transfer will be allowed to continue.
Gateway Action
allow_data
Recommended Action
Change Fail Mode parameter to Deny if files that fail decompression
should be blocked. Increase the Max. Archive Depth parameter to
allow deeper files to be scanned.
Revision
1
Parameters
filename
max_depth
[layer7_srcinfo]
[layer7_dstinfo]
Context Parameters
ALG Module Name
ALG Session ID
Connection
2.3.24. unknown_encoding (ID: 05800182)
Default Severity
Chapter 2: Log Message Reference
180
Summary of Contents for NetDefend DFL-260E
