2
Hardware Installation
System Requirements
•
Internet Explorer 5.x or above
•
CPU: Pentium III, 800 MHz or above (Required for use with
IP surveillance
software)
•
Memory Size: 128 MB (256 MB recommended)
•
VGA card resolution: 800x600 or above
Connect the Ethernet Cable
It is recommended that the
DCS-5300W
be connected to
an Ethernet cable for initial configuration. Connect one end
of the Ethernet cable to the network cable connector
located on the Internet Camera’s back panel and attach
the other end to a router, switch, or gateway on the
network.
Attach the Antennas to the Camera
If you will be using the
DCS-5300W
in a wireless network,
attach the antennas to the back of the camera by turning
the antennas in the clockwise direction until snug, do not
over tighten.
If you connect this camera directly to
a PC, you will need a cross-over
Ethernet cable. If you plug the camera into a
hub or router, you will be able to use the cable
included with your camera.
Summary of Contents for SECURICAM Network DCS-5300W
Page 9: ...NOTES ...
