5 Configuration
D-Link Web Smart Switch User Manual
30
System > SysLog Host Settings
The SysLog Host Settings page allows user to send Syslog messages to up to four designated servers using
the System Log Server. To set the System Log Server configuration, click Apply.
Figure 5.22 – System > SysLog Host Settings
System Log: Enabled or Disabled the SysLog Host feature. It supports maximum 500 system log entries.
Server IP Address: Select IPv4 or IPv6 and specifies the IP address of the system log server.
UDP Port (1 - 65535): Specifies the UDP port to which the server logs are sent. The possible range is 1 –
65535, and the default value is 514.
Time Stamp: Select Enable to time stamp log messages.
Severity: Specifies the minimum severity from which warning messages are sent to the server. There are
three levels. When a severity level is selected, all severity level choices above the selection are selected
automatically. The possible levels are:
Warning - The lowest level of a device warning. The device is functioning, but an operational
problem has occurred.
Informational - Provides device information.
All - Displays all levels of system logs.
Facility: Specifies an application from which system logs are sent to the remote server. Only one facility can
be assigned to a single server. If a second facility level is assigned, the first facility is overwritten. There are
up to eight facilities can be assigned (Local 0 ~ Local 7).
System > Time Profile
The Time Profile page allows users to configure the time profile settings of the device.
Figure 5.23 – System > Time Profile Settings
Profile Name: Specifies the profile name.
Time(HH MM): Specifies the Start Time and End Time.
Weekdays: Specifies the work day.
Date: Select Date and specifies the From Day and To Day of the time profile.
Click Add to create a new time profile or click Delete to delete a time profile from the table.
NOTE: The time must be set after current time,
otherwise it will take effect on the next cycle time.
