xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
config bandwidth_control
<value 1-9999>
−
Specifies the packet limit, in Mbps, that the
above ports will be allowed to transmit.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure bandwidth control:
DES-6500:4#config bandwidth_control 1:1-1:10 tx_rate 10
Command: config bandwidth_control 1:1-1:10 tx_rate 10
Success.
DES-6500:4#
show bandwidth_control
Purpose
Used to display the bandwidth control configuration on the Switch.
Syntax
show bandwidth_control {<portlist>}
Description
The
show bandwidth_control
command displays the current
bandwidth control configuration on the Switch, on a port-by-port
basis.
Parameters
<portlist>
−
Specifies a range of ports to be displayed. The port list
is specified by listing the lowest slot number and the beginning
port number on that slot, separated by a colon. Then the highest
slot number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
slot number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4
specifies all of the ports between slot 1, port 3 and slot 2, port 4
−
in numerical order.
Using this command without adding a portlist entry will show the
bandwidth control for all ports in the Switch stack.
Restrictions None.
Example usage:
To display bandwidth control settings:
104
