xStack DES-6500 Modular Layer 3 Chassis Ethernet Switch CLI Manual
36
RIP C
OMMANDS
The RIP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
config rip
[ipif <ipif_name 12> | all] {authentication [enabled <password
16> | disabled] | tx_mode [disabled | v1_only | v1_compatible |
v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 | disabled]
state [enabled | disabled]}
enable rip
disable rip
show rip
ipif <ipif_name 12>
Each command is listed, in detail, in the following sections.
config rip
Purpose
Used to configure RIP on the Switch.
Syntax
config rip [ipif <ipif_name 12> | all] {authentication [enabled
<password 16> | disabled] | tx_mode [disabled | v1_only |
v1_compatible | v2_only] | rx_mode [v1_only | v2_only |
v1_or_v2 | disabled] state [enabled | disabled]}
Description
This command is used to configure RIP on the Switch.
Parameters
<ipif_name 12>
−
The name of the IP interface.
all
– To configure all RIP receiving mode for all IP interfaces.
authentication [enabled | disabled]
−
Enables or disables
authentication for RIP on the Switch.
tx_mode
−
Determines how received RIP packets will be
interpreted – as RIP version
V1 only
,
V2 Only
,
or
V1 Compatible
(V1 and V2)
.
This entry specifies which version of the RIP
protocol will be used to transfer RIP packets. The disabled entry
prevents the reception of RIP packets.
rx_mode
−
Determines how received RIP packets will be
interpreted – as RIP version
V1 only, V2 Only
,
or
V1 or V2
.
This entry specifies which version of the RIP protocol will be
used to receive RIP packets. The Disabled entry prevents the
•
<password 16>
−
Allows the specification of a case-
sensitive password.
•
disable
−
Prevents the transmission of RIP packets.
•
v1_only
−
Specifies that only RIP v1 packets will be
transmitted.
•
v1_compatible –
Specifies that only RIP v1 compatible
packets will be transmitted.
•
v2_only
- Specifies that only RIP v2 packets will be
transmitted.
287
