DES-6500
15
P
ORT
M
IRRORING
C
OMMANDS
The port mirroring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config mirror port
<port> [add|delete]
source ports <portlist> [rx|tx|both]
enable mirror
disable mirror
show mirror
Each command is listed, in detail, in the following sections.
config mirror port <port> add
Purpose
Used to configure a mirror port
−
source port pair on the switch.
Syntax
config mirror port <port> add source ports <portlist> [rx|tx|both]
Description
This command allows a range of ports to have all of their traffic also
sent to a designated port, where a network sniffer or other device can
monitor the network traffic. In addition, you can specify that only traffic
received by or sent by one or both is mirrored to the Target port.
Parameters
<port>
−
This specifies the Target port (the port where mirrored packets
will be sent).
source ports – The port or ports being mirrored. This cannot include the
Target port.
<portlist>
−
This specifies a range of ports that will be mirrored. That is,
the range of ports in which all traffic will be copied and sent to the
Target port. The port list is specified by listing the lowest slot number
and the beginning port number on that slot, separated by a colon. Then
the highest slot number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port
list range are seperated by a dash. For example, 1:3 specifies slot
number 1, port 3. 2:4 specifies slot number 2, port 4. 1:3-2:4 specifies
all of the ports between slot 1, port 3 and slot 2, port 4
−
in numerical
order.
rx
−
Allows the mirroring of only packets received by (flowing into) the
port or ports in the port list.
tx
−
Allows the mirroring of only packets sent to (flowing out of) the port
or ports in the port list.
both
−
Mirrors all the packets received or sent by the port or ports in the
port list.
Restrictions
The Target port cannot be listed as a source port. Only administrator-
level users can issue this command.
Example usage:
To add the mirroring ports:
Summary of Contents for TM DES-6500
