17
L
INK
A
GGREGATION
C
OMMANDS
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
create link_aggregation
group_id <value 1-32> {type[lacp|static]}
delete link_aggregation
group_id <value1-32>
config link_aggregation
group_id <value1-32>
master_port <port>
ports <portlist>
state [enabled|disabled]
config link_aggregation
algorithm
mac_source
mac_destination
mac_source_dest
ip_source
ip_destination
ip_source_dest
show link_aggregation
group_id <value1-32>
algorithm
config lacp_ports
<portlist> mode [active|passive]
show lacp_ports
{<portlist>}
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose
Used to create a link aggregation group on the switch.
Syntax
create link_aggregation group_id <value1-32> {type[lacp|static]}
Description
This command will create a link aggregation group with a unique
identifier.
Parameters
<value 1-32>
−
Specifies the group id. The switch allows up to 32 link
aggregation groups to be configured. The group number identifies each
of the groups.
type – Specify the type of link aggregation used for the group. If the type
is not specified the default type is static.
lacp – This designates the port group as LACP compliant. LACP allows
dynamic adjustment to the aggregated port group. LACP compliant
ports may be further configured (see config lacp_ports). LACP
compliant must be connected to LACP compliant devices.
static – This designates the aggregated port group as static. Static port
groups can not be changed as easily as LACP compliant port groups
since both linked devices must be manually configured if the
configuration of the trunked group is changed. If static link aggregation
is used, be sure that both ends of the connection are properly
configured and that all ports have the same speed/duplex settings.
Restrictions Only
administrator-level users can issue this command.
Summary of Contents for TM DES-6500
