DES-6500:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID : 1
TYPE : TRUNK
Master Port : 1:5
Member Port : 1:5-1:10
Active Port : 1:5-1:10
Status : Enabled
Flooding Port : 1:6
config lacp_ports
Purpose
Used to configure settings for LACP compliant ports.
Syntax
config lacp_ports <portlist> mode [active|passive]
Description
This command is used to configure ports that have been previously
designated as LACP ports (see create link_aggregation).
Parameters
<portlist>
−
Specifies a range of ports to be configured. The port list is
specified by listing the lowest slot number and the beginning port
number on that slot, separated by a colon. Then the highest slot
number, and the highest port number of the range (also separated by a
colon) are specified. The beginning and end of the port list range are
seperated by a dash. For example, 1:3 specifies slot number 1, port 3.
2:4 specifies slot number 2, port 4. 1:3-2:4 specifies all of the ports
between slot 1, port 3 and slot 2, port 4
−
in numerical order.
mode – Select the mode to determine if LACP ports will initially send
LACP control frames.
active – Active LACP ports are capable of processing and sending LACP
control frames. This allows LACP compliant devices to negotiate the
aggregated link so the group may be changed dynamically as needs
require. In order to utilize the ability to change an aggregated port group,
that is, to add or subtract ports from the group, at least one of the
participating devices must designate LACP ports as active. Both devices
must support LACP. Only one side is designated active while the other
side is designated passive.
passive – LACP ports that are designated as passive cannot initially
send LACP control frames, unless it receives LACP control frames on
the port. In order to allow the linked port group to negotiate adjustments
and make changes dynamically, at one end of the connection must have
“active” LACP ports (see above).
Restrictions Only
administrator-level users can issue this command.
Note: For LACP implementations, both devices utilizing the
aggregated link must support IEEE 802.3ad Link Aggregation Control
Protocol and one device must designate the participating ports as
“active” while this other device must designate the participating
ports as “passive”.
Summary of Contents for TM DES-6500
