DES-6500
25
R
OUTING
T
ABLE
C
OMMANDS
The routing table commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create iproute
default
<network_address>
<ipaddr>
<metric 1-65535>
delete iproute
default
<network_address>
show iproute
<network_address>
static
rip
ospf
Each command is listed, in detail, in the following sections.
create iproute
Purpose
Used to create IP route entries to the switch’s IP routing table.
Syntax
create iproute [default | <network_address>] <ipaddr> {<metric>}
Description
This command is used to create an IP route entry to the switch’s IP
routing table.
Parameters
default
−
creates a default IP route entry.
<network_address>
−
IP address and netmask of the IP interface that is
the destination of the route. You can specify the address and mask
information using the traditional format (for example, 10.1.2.3/255.0.0.0
or in CIDR format, 10.1.2.3/8).
<ipaddr>
−
The IP address for the next hop router.
<metric>
−
The default setting is 1.
Restrictions Only
administrator-level users can issue this command.
Summary of Contents for TM DES-6500
