DES-6500
28
B
OOTP
R
ELAY
C
OMMANDS
The BOOTP relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config bootp_relay
hops <value 1-16>
time <sec 0-65535>
config bootp_relay add
ipif <ipif_name 12>
<ipaddr>
config bootp_relay delete
ipif <ipif_name 12>
<ipaddr>
enable bootp_relay
disable bootp_relay
show bootp_relay
ipif <ipif_name>
Each command is listed, in detail, in the following sections.
config bootp_relay
Purpose
Used to configure the BOOTP relay feature of the switch.
Syntax
config bootp_relay {hops <value>} {time <sec>}
Description
This command is used to configure the BOOTP relay feature.
Parameters
hops <value>
−
Specifies the maximum number of relay agent hops that
the BOOTP packets can cross.
time <sec>
−
If this time is exceeded, the switch will relay the BOOTP
packet.
Restrictions Only
administrator-level users can issue this command.
Example Usage:
To configure bootp relay status.
DES-6500:4#config bootp_relay hops 4 time 2
Command: config bootp_relay hops 4 time 2
Success.
DES-6500:4#
config bootp_relay add
Purpose
Used to add an IP destination address to the switch’s BOOTP relay
table.
Summary of Contents for TM DES-6500
