DES-6500
DES-6500:4#config ospf ipif System priority 2 hello_interval
15 metric 2 state enabled
Command: config ospf ipif System priority 2 metric 2 state
enabled hello_interval 15
Success.
DES-6500:4#
config ospf all
Purpose
Used to configure all of the OSPF interfaces on the switch at one time.
Syntax
config ospf all {area <area_id>/priority <value 0-255>/hello_interval
<sec 1-65535>/dead_interval <sec 1-65535>/authentication
[none/simple <password>/md5 <key_id>]/metric <value 0-
65535>/state [enabled/disabled]}
Description
This command is used to configure all of the OSPF interfaces on the
switch, using a single group of parameters, at one time.
Parameters
priority <value 0-255>
−
The priority used in the election of the
Designated Router (DR). A number between 0 and 255.
metric <value 0-65535>
−
The interface metric (0 to 65535). Entering a 0
will allow automatic calculation of the metric.
hello_interval <sec 1-65535>
−
Allows the specification of the interval
between the transmission of OSPF Hello packets, in seconds. Between
1 and 65535 seconds can be specified. The Hello Interval, Dead
Interval, Authorization Type, and Authorization Key should be the same
for all routers on the same network.
dead_interval <sec 1-65535>
−
Allows the specification of the length of
time between the receipt of Hello packets from a neighbor router before
the selected area declares that router down. An interval between 1 and
65535 seconds can be specified. The Dead Interval must be evenly
divisible by the Hello Interval.
Parameters
<password>
−
A case-sensitive password.
<key_id>
−
A previously configured MD5 key ID (1 to 255).
metric <value>
−
This field allows the entry of a number between 1 and
65,535 that is representative of the OSPF cost of reaching the selected
OSPF interface. The default metric is 1.
Restrictions Only
administrator-level users can issue this command.
Usage Example
To configure all of the OSPF interfaces on the switch with a single group of parameters:
Summary of Contents for TM DES-6500
