DES-6500:4#create syslog host 1 severity all facility local0
Command: create syslog host 1 severity all facility local0
Success.
DES-6500:4#
config syslog host
Purpose
Used to configure the syslog protocol to send system log data to a
remote host.
Syntax
config syslog host [all|<index 1-4>] {severity
[informational|warning|all]| facility[local0|local1|local2|local3|
local4|local5|local6|local7]|udp_port <udp_port_number>|
ipaddress <ipaddr>| state[enabled|disabled]
Description
The
config syslog host
command is used to configure the syslog
protocol to send system log information to a remote host.
Parameters
all
−
Specifies that the command will be applied to all hosts.
<index 1-4>
−
Specifies that the command will be applied to an index of
hosts. There are four available indexes, numbered 1 through 4.
severity
−
Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently
supported on the switch.
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
informational
−
Specifies that informational messages will be sent to the
remote host. This corresponds to number 6 from the list above.
warning
−
Specifies that warning messages will be sent to the remote
host. This corresponds to number 4 from the list above.
all
−
Specifies that all of the currently supported syslog messages that
are generated by the switch will be sent to the remote host.
facility
−
Some of the operating system daemons and processes have
been assigned Facility values. Processes and daemons that have not
been explicitly assigned a Facility may use any of the"local use"
facilities or they may use the "user-level" Facility. Those Facilities that
have been designated are shown in the following: Bold font indicates
that the facility values the switch currently supports.
Numerical Facility
Code
0 kernel messages
1 user-level messages
2 mail system
3 system daemons
4 security|authorization messages
5 messages generated internally by syslog
6 line printer subsystem
Summary of Contents for TM DES-6500
