DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
170
Transmit Delay
A read only field that denotes the estimated time to transmit a Link State Update
Packet over this interface, in seconds.
Retransmit Time
A read only field that denotes the time between LSA retransmissions over this
interface, in seconds.
OSPF Virtual Interface Settings
Click the
OSPF Virtual Interface Setting
s link to view the current
OSPF Virtual Interface Settings
. There are not
virtual interface settings configured by default, so the first time this table is viewed there will be not interfaces listed. To
add a new OSPF virtual interface configuration set to the table, click the
Add
button. A new menu appears (see below). To
change an existing configuration, click on the hyperlinked
Transit Area ID
for the set you want to change. The menu to
modify an existing set is the same as the menu used to add a new one. To eliminate an existing configuration, click the
in the
Delete
column.
Figure 6- 133. OSPF Virtual Link Settings
The status of the virtual interface appears (Up or Down) in the
Status
column.
Figure 6- 134. OSPF Virtual Link Settings – Add
Configure the following parameters if you are adding or changing an
OSPF Virtual Interface
:
Parameter Description
Transit Area ID
Allows the entry of an OSPF Area ID
−
previously defined on the Switch
−
that allows
a remote area to communicate with the backbone (area 0). A Transit Area cannot be a
Stub Area or a Backbone Area.
Summary of Contents for TM DES-6500
