DES-6500 Chassis-based Layer 3 Ethernet Switch Manual
224
SNMP Host Table
Use the
SNMP Host Table
to set up SNMP trap recipients.
Open the
SNMP Manager
folder and click on the
SNMP Host Table
link. This will open the
SNMP Host Table
page, as
shown below.
To delete an existing
SNMP Host Table
entry, click the corresponding
under the
Delete
heading.
To display the current settings for an existing
SNMP Group Table
entry, click the blue link for the entry under the
Host
IP Address
heading.
Figure 8- 37. SNMP Host Table
To add a new entry to the Switch's
SNMP Host Table
, click the
Add
button in the upper left-hand corner of the page.
This will open the
SNMP Host Table Configuration
page, as shown below.
Figure 8- 38. SNMP Host Table Configuration window
The following parameters can set:
Parameter Description
Host IP Address
Type the IP address of the remote management station that will serve as the SNMP
host for the Switch.
SNMP Version
V1
- To specifies that SNMP version 1 will be used.
V2
- To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv
- To specify that the SNMP version 3 will be used, with a
NoAuth-NoPriv security level.
V3-Auth-NoPriv
- To specify that the SNMP version 3 will be used, with an Auth-
NoPriv security level.
V3-Auth-Priv
- To specify that the SNMP version 3 will be used, with an Auth-Priv
security level.
Community String or
SNMP V3 User Name
Type in the community string or SNMP V3 user name as appropriate.
To implement your new settings, click
Apply.
To return to the
SNMP Host Table
, click the
Show All SNMP Host Table
Entries
link.
Summary of Contents for TM DES-6500
