5 Configuration
D-Link Web Smart Switch User Manual
Select the OUI and press
Add
to the lower table to complete the Auto Voice VLAN setting.
Configuration > Link Aggregation > Port Trunking
The Trunking function enables the combining of two or more ports together to increase bandwidth. Up to
eight Trunk groups may be created, and each group consists up to eight ports. Select the ports to be
grouped together, and then click
Apply
to activate the selected Trunking groups. Two types of link
aggregation can be selected:
Static -
Static link aggregation.
LACP -
LACP (Link Aggregation Control Protocol) is enabled on the device. LACP allows for the
automatic detection of links in a Port Trunking Group.
Disable -
Remove all members in this trunk group.
Figure 63 – Configuration > Link Aggregation > Port Trunking
NOTE:
Each combined trunk port must be
connected to devices within the same VLAN
group.
Configuration > Link Aggregation > LACP Port Settings
The
LACP Port Settings
is used to create port trunking groups on the Switch. The user may set which ports
will be active and passive in processing and sending LACP control frames
Figure 64 – Configuration > Link Aggregation > LACP Port Settings
From Port:
The beginning of a consecutive group of ports may be configured starting with the selected port.
To Port:
The ending of a consecutive group of ports may be configured starting with the selected port.
3
3
7
7
Summary of Contents for Web Smart Switch DGS-1210-16
Page 1: ......
Page 30: ...5 Configuration D Link Web Smart Switch User Manual Figure 42 User Guide Micro Site 26...
Page 71: ......
