Configuration
D-Link Web Smart Switch User Manual
2
2
7
7
Server IP Address:
Specifies the IPv4 address of the system log server.
UDP Port:
Specifies the UDP port to which the server logs are sent. The possible range is from 1 to 65535.
The default value is
514
.
Time Stamp
: Select
Enabled
to time stamp log messages.
Severity:
Specifies the minimum severity from which warning messages are sent to the server. There are
three levels. When a severity level is selected, all severity level choices above the selection are selected
automatically. The possible levels are:
Warning -
The lowest level of a device warning. The device is functioning, but an operational
problem has occurred.
Informational -
Provides device information.
All -
Displays all levels of system logs.
Facility:
Specifies an application from which system logs are sent to the remote server. Only one facility can
be assigned to a single server. If a second facility level is assigned, the first facility is overwritten. There are
up to eight facilities can be assigned (Local 0 to Local 7).
The Time Profile window allows users to configure the time profile settings of the device.
System > Time Profile
Figure 4.24 – System > Time Profile
Profile Name:
Specifies the profile name.
Time(HH MM):
Specifies the
Start Time
and
End Time
.
Weekdays:
Specifies the week days.
Date:
Select
Date
and specifies the
From Day
and
To Day
of the time profile.
Click
Add
to create a new time profile or click
Delete
to delete a time profile from the table.
The Power Saving mode feature reduces power consumption automatically when the RJ-45 port is link down
or the connected devices are turned off. Less power will be consumed also when the short cable is used
(less than 20 meters).
System > Power Saving
By reducing power consumption, less heat is produced, resulting in extended product life and lower
operating costs. By default, the
Cable Length Detection
and
Link Status Detection
are
Enabled
. Click
Apply
to make the change effective.
