xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
179
config cpu access_profile
source_ip <ipaddr>
−
Specifies that the access profile will apply to only
packets with this source IP address.
destination_ip <ipaddr>
−
Specifies that the access profile will apply to
only packets with this destination IP address.
dscp <value 0-63>
−
Specifies that the access profile will apply only to
packets that have this value in their Type-of-Service (DiffServ code
point, DSCP) field in their IP packet header
icmp
−
Specifies that the Switch will examine the Internet Control
Message Protocol (ICMP) field within each packet.
type <value 0-255>
−
Specifies that the access profile will apply to
this ICMP type value.
code <value 0-255>
−
Specifies that the access profile will apply
to this ICMP code.
igmp
−
Specifies that the Switch will examine the Internet Group
Management Protocol (IGMP) field within each packet.
type <value 0-255>
−
Specifies that the access profile will apply to
packets that have this IGMP type value.
tcp
−
Specifies that the Switch will examine the Transmission Control
Protocol (TCP) field within each packet.
src_port <value 0-65535>
−
Specifies that the access profile will
apply only to packets that have this TCP source port in their
TCP header.
dst_port <value 0-65535>
−
Specifies that the access profile will
apply only to packets that have this TCP destination port in
their TCP header.
protocol_id <value 0-255>
−
Specifies that the switch will examine the
Protocol field in each packet and if this field contains the value
entered here, apply the following rules.
udp
−
Specifies that the Switch will examine the Transmission Control
Protocol (TCP) field within each packet.
src_port <value 0-65535>
−
Specifies that the access profile will
apply only to packets that have this UDP source port in their
header.
dst_port <value 0-65535>
−
Specifies that the access profile will
apply only to packets that have this UDP destination port in
their header.
protocol_id <value 0-255>
−
Specifies that the Switch will examine the
protocol field in each packet and if this field contains the value entered
here, apply the following rules.
•
user_define_mask <hex 0x0-0xffffffff>
−
Specifies that the rule
applies to the IP protocol ID and the mask options behind the IP
header.
•
packet_content_mask
– Specifies that the Switch will mask the packet
header beginning with the offset value specified as follows:
•
offset_0-15
- Enter a value in hex form to mask the packet from
byte 0 to byte 15.
•
offset_16-31
- Enter a value in hex form to mask the packet from
byte 16 to byte 31.
•
offset_32-47
- Enter a value in hex form to mask the packet from
byte 32 to byte 47.
•
offset_48-63
- Enter a value in hex form to mask the packet from
