xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
190
DES-3800:4#config time 30jun2003 16:30:30
Command: config time 30jun2003 16:30:30
Success.
DES-3800:4#
config time_zone
Purpose
Used to determine the time zone used in order to adjust the system
clock.
Syntax
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min
<minute 0-59>}
Description
This will adjust system clock settings according to the time zone.
Time zone settings will adjust SNTP information accordingly.
Parameters
operator
– Choose to add (+) or subtract (-) time to adjust for time
zone relative to GMT.
hour
– Select the number of hours different from GMT.
min
– Select the number of minutes difference added or subtracted
to adjust the time zone.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure time zone settings:
DES-3800:4#config time_zone op hour 2 min 30
Command: config time_zone op hour 2 min 30
Success.
DES-3800:4#
config dst
Purpose
Used to enable and configure time adjustments to allow for the use of
Daylight Savings Time (DST).
Syntax
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day
<start_day sun-sat> | s_mth <start_mth 1-12> | s_time start_time
hh:mm> | e_week <end_week 1-4,last> | e_day <end_day sun-sat> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90
| 120]} | annual {s_date start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]}]
Description DST can be enabled and configured using this command. When enabled
this will adjust the system clock to comply with any DST requirement. DST
adjustment effects system time for both manually configured time and time
set using SNTP service.
