xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
244
Command: delete ospf aggregation 10.1.1.1 10.48.76..122/16 lsdb_type summary
Success.
DES-3800:4#
config ospf aggregation
Purpose
Used to configure the OSPF area aggregation settings.
Syntax
config ospf aggregation <area_id> <network_address>
lsdb_type summary {advertise [enable | disable]}
Description
This command is used to configure the OSPF area aggregation
settings.
Parameters
<area_id>
−
A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<network_address>
−
The 32-bit number in the form of an IP
address that uniquely identifies the network that corresponds to
the OSPF Area.
lsdb_type summary
−
Specifies the type of address aggregation.
advertise [enable | disable]
−
Allows for the advertisement trigger
to be enabled or disabled.
Restrictions Only
administrator-level users can issue this command.
Usage Example
To configure the OSPF area aggregation settings:
DES-3800:4#config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enable
Command: config ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type
summary advertise enable
Success.
DES-3800:4#
show ospf aggregation
Purpose
Used to display the current OSPF area aggregation settings.
Syntax
show ospf aggregation {<area_id>}
Description
This command will display the current OSPF area aggregation
settings.
Parameters
<area_id>
−
Enter this parameter if you wish to view this table by
a specific OSPF area ID.
Restrictions None.
Usage Example
