xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
251
config ospf virtual_link
that uniquely identifies the remote area’s Area Border Router.
hello_interval <sec 1-65535>
−
Allows the specification of the
interval between the transmission of OSPF Hello packets, in
seconds. Between 1 and 65535 seconds can be specified. The
Hello Interval, Dead Interval, Authorization Type, and
Authorization Key should be the same for all routers on the same
network.
dead_interval <sec 1-65535>
−
Allows the specification of the
length of time between the receipt of Hello packets from a
neighbor router before the selected area declares that router
down. An interval between 1 and 65535 seconds can be
specified. The Dead Interval must be evenly divisible by the Hello
Interval.
authentication
– Enter the type of authentication preferred. The
user may choose between:
none
– Choosing this parameter will require no
authentication.
simple <password 8>
−
Choosing this parameter will set a
simple authentication which includes a case-sensitive
password of no more than 8 characters.
md5 <key_id 1-255>
−
Choosing this parameter will set
authentication based on md5 encryption. A previously
configured MD5 key ID (1 to 255) is required.
Restrictions Only
administrator-level users can issue this command.
Usage Example
To configure the OSPF virtual interface settings:
DES-3800:4#config ospf virtual_link 10.1.1.2 20.1.1.1 hello_interval 10
Command: config ospf virtual_link 10.1.1.2 20.1.1.1 hello_interval 10
Success.
DES-3800:4#
delete ospf virtual_link
Purpose
Used to delete an OSPF virtual interface.
Syntax
delete ospf virtual_link <area_id> <neighbor_id>
Description
This command will delete an OSPF virtual interface from the
Switch.
Parameters
<area_id>
−
A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the
OSPF domain.
<neighbor_id>
−
The OSPF router ID for the remote area. This is
a 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx)
that uniquely identifies the remote area’s Area Border Router.
The router ID of the neighbor router.
Restrictions Only
administrator-level users can issue this command.
