xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual
48
Example Usage:
To prevent SNMP traps from being sent from the Switch:
DES-3800:4#disable snmp traps
Command: disable snmp traps
Success.
DES-3800:4#
disable snmp authenticate traps
Purpose
Used to disable SNMP authentication trap support.
Syntax
disable snmp authenticate traps
Description
This command is used to disable SNMP authentication support on
the Switch.
Parameters None.
Restrictions Only
administrator-level users can issue this command.
Example Usage:
To disable the SNMP authentication trap support:
DES-3800:4#disable snmp authenticate traps
Command: disable snmp authenticate traps
Success.
DES-3800:4#
config snmp system_contact
Purpose
Used to enter the name of a contact person who is responsible for
the Switch.
Syntax
config snmp system_contact <sw_contact>
Description The
config snmp system_contact
command is used to enter the
name and/or other information to identify a contact person who is
responsible for the Switch. A maximum of 255 character can be
used.
Parameters
<sw_contact>
- A maximum of 255 characters is allowed. A NULL
string is accepted if there is no contact.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure the Switch contact to “
M I S D e p a r t m e n t I I
”:
DES-3800:4#config snmp system_contact MIS Department II
Command: config snmp system_contact MIS Department II
