xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
591
Chapter 64
QinQ Command List (EI
Mode Only)
enable qinq
disable qinq
config qinq inner_tpid
<hex 0x1-0xffff>
config qinq ports
[<portlist> | all] {role [uni | nni] | missdrop [enable | disable] | outer_tpid <hex
0x1 - 0xffff> | use_inner_priority [enable | disable] | add_inner_tag [<hex 0x1 - 0xffff> |
disable]}
show qinq
show qinq inner_tpid
show qinq ports
{<portlist>}
create vlan_translation ports
[<portlist> | all] [add cvid <vidlist> | replace cvid <vlanid 1-4094>]
svid <vlanid 1-4094> {priority <priority 0-7>}
delete vlan_translation ports
[<portlist> | all] {cvid <vidlist>}
show vlan_translation
{[ports <portlist> | cvid <vidlist>]}
64-1
enable qinq
Description
This command is used to enable QinQ. When QinQ is enabled, all network port roles will be NNI
ports and outer TPID will be set to 0x88A8; all existing static VLANs will run as S-VLAN; all
dynamic learned L2 address will be cleared; all dynamic registered VLAN entries will be cleared;
and GVRP will be disabled.
To run GVRP on the Switch, the administrator should enable GVRP manually. In QinQ mode,
GVRP protocol will employ reserve address 01-80-C2-00-00-0D.
Format
enable qinq
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable QinQ:
Summary of Contents for xStack DGS-3120-24PC
Page 1: ......
Page 42: ...xStack DGS 3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide 38...
Page 168: ...xStack DGS 3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide 164...
Page 765: ...xStack DGS 3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide 761...