xStack
®
DGS-3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
764
Chapter 88
Trusted Host Command List
create trusted_host
[<ipaddr> |<ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] {snmp | telnet | ssh | http | https | ping}
delete trusted_host
[ipaddr <ipaddr> | ipv6address <ipv6addr> | network <network_address> |
ipv6_prefix <ipv6networkaddr> | all]
config trusted_host
[<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] [add | delete] {snmp | telnet | ssh | http | https | ping | all}
show trusted_host
88-1
create trusted_host
Description
This command is used to create the trusted host. The switch allows you to specify up to three IP
addresses that are allowed to manage the Switch via in-band SNMP or TELNET based
management software. These IP addresses must be members of the Management VLAN. If no IP
addresses are specified, then there is nothing to prevent any IP address from accessing the
Switch, provided the user knows the Username and Password.
When the access interface is not specified, the trusted host will be created for all interfaces.
Format
create trusted_host [<ipaddr> |<ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] {snmp | telnet | ssh | http | https | ping}
Parameters
<ipaddr>
- The IP address of the trusted host.
<ipv6addr>
- The IPv6 address of the trusted host.
(EI Mode Only)
network
- The network address of the trusted network. The form of network address is
xxx.xxx.xxx.xxx/y.
<network_address>
- Enter the network address used here.
ipv6_prefix
– Specify that IPv6 prefix here.
(EI Mode Only)
<ipv6networkaddr>
- Enter the IPv6 network address here.
snmp
- (Optional) Specify trusted host for SNMP.
telnet
- (Optional) Specify trusted host for TELENT.
ssh
- (Optional) Specify trusted host for SSH
http
- (Optional) Specify trusted host for HTTP
https
- (Optional) Specify trusted host for HTTPs.
ping
- (Optional) Specify trusted host for PING
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create the trusted host:
Summary of Contents for xStack DGS-3120-24PC
Page 1: ......
Page 42: ...xStack DGS 3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide 38...
Page 168: ...xStack DGS 3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide 164...
Page 765: ...xStack DGS 3120 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide 761...