xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
807
81-5
config pim6 crp
Description
This command is used to configure the PIM6 C-RP related parameters.
Format
config pim6 crp [rp <ipif_name 12> | all] {priority <value 0-255> | interval <sec 1-16383>}(1)
Parameters
ipif
- Specify to apply the configurations to this specific IP interface.
<ipif_name 12>
- Enter the IP interface name.
all
- Specify to apply the configurations to all IP interfaces.
priority
- Specify for RP election.
<value 0-255>
- Enter the value between 0 and 255. The lower the value is, the higher the
priority is. The default value is 192.
interval
- Specify the C-RP advertisement interval in seconds.
<sec 1-16383>
- Enter the interval between 1 and 16383 seconds. The default value is 60.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the C-RP priority and the interval on the interface “System”:
DGS-3120-24TC:admin#config pim6 crp rp System priority 60 interval 60
Command: config pim6 crp rp System priority 60 interval 60
Success.
DGS-3120-24TC:admin#
81-6
create pim6 crp group
Description
This command is used to add a multicast group range into a C-RP serve list.
Format
create pim6 crp group <ipv6networkaddr> rp <ipif_name 12>
Parameters
<ipv6networkaddr>
- Specify the IPv6 group address range served by the RP.
rp
- Specify the interface act as a C-RP.
<ipif_name 12>
- Enter the IP interface name.
Summary of Contents for xStack DGS-3120 Series
